Now here is a method to make multiply HST's
but
it does involve a bit of marking!
Start with 2 - 10" squares
(one light and one dark)
with right sides together,
mark the half way line(5") going both ways. on the light square
Next - Mark a line corner to corner in both directions
next mark a line from center line to center line diagonally
Now you are ready to sew!
These dotted lines are where you will sew 1/4" along the solid lines
EXCEPT
the two center lines!
When all lines are sewn you can start the cutting process
Cut down the two center lines

Then corner to corner on each square

Then in half both ways on each quadrant!
This yields 32 HST's at a time
Press the HST's to the dark side!
In case that was as clear as mud...
Here is a little video!
We are not far from putting some components together!
Till next week....
Ps. you can find the kit at the link below!






No comments:
Post a Comment
Thank you for reading and hope your enjoyed!!